Source Audio Soundblox Pro Multiwave Distortion Pro - Manual (Page 5)

Controls: Knobs | 9 8 | Connections
CONTROLS: KNOBS
EFFECT (not labeled)
The effect knob selects which distortion type will be used. There are
23
effect positions ( 0 through 22 ) around the knob as well as a setting for
CLEAN BOOST/EQ . In the CLEAN BOOST/EQ mode, the distortion effect is
bypassed but the output, mix, and equalizer still apply. For information
on the individual settings see the Effect Types section.
SUSTAIN
There is a compressor before the distortion. The
SUSTAIN knob adjusts
the input gain of the compressor. The compression ratio and output vol-
ume can be adjusted as Backpage Parameters. Increasing the
SUSTAIN
control will result in a higher signal level going to the distortion, even
when
DRIVE remains fixed. Increasing the amount of compression on the
signal effectively creates more sustain.
CONNECTIONS
GUITAR IN
Connect your guitar or other instrument here using a standard
MONO
¼" cable.
GUITAR OUT
Connect this to your amp, pedal, or other audio device.
EXPRESSION IN (optional)
Connect a passive expression pedal that uses a
TRS plug here. Allows
morphing of sounds between banks A and B.
SENSOR IN (optional)
Connect an optional Hot Hand sensor here, either wired or wireless.
SENSOR OUT (optional)
Use a Source Audio daisy-chain cable to connect this jack to the sensor
input of another pedal.
MIDI IN (optional)
MIDI program and continuous control input. Connect to a MIDI output
with a standard MIDI cable
9V DC
Connect the included
9 Volt DC power supply here. Use of a non-Source
Audio power supply may cause damage and void the warranty.
17
MULTI BAND
SINGLE BAND
02
03
04
05
06
07
08
09
10 11 12
13
14
15
16
18
19
21
22
CLEAN BOOST / EQ
00
20
01
OCTAVE
NORMAL
FOLDBACK
OCTAVE
NORMAL
FOLDBACK
SUSTAIN
SENSOR
IN
SENSOR
OUT
GUITAR IN GUITAR OUT
9V DC
EXP IN
MIDI IN
- Continued