Source Audio Soundblox 2 Manta Bass Filter - Manual (Page 26)

26 | Specifications
Dimensions
• L: 4.5 inches
• W: 4.5 inches
• H: 2.25 inches (including knobs)
Weight
• 1.00 lbs
Power
• 140mA @ 9V DC (max 180mA with Hot
Hand Wireless Adapter)
• Negative tip power jack
Audio Performance
• Maximum input level: 2.0 Vrms (+6 dBV)
• Input impedance: 1 MOhm
• Output impedance: 1 kOhm
• 115dB DNR audio path
• 24-bit audio conversion
• 56-bit digital data path
• Universal Bypass™ (buffered or relay-
based true bypass)
SPECIFICATIONS
TROUBLESHOOTING
Noise:
Power Source Ensure that the proper power supply is being used.
Near noise source Move pedal away from power supplies and other equipment.
Other equipment Remove other effects from signal chain, see if noise persists.
Bad cables Swap out audio cables.
Hot Hand doesn’t work:
Low power Ensure that the proper power supply is being used.
Not calibrated properly Calibrate the Hot Hand — see page 24.
Not connected properly Check Hot Hand connections.
General:
Restore Factory Settings Press and hold CONTROL INPUT button while powering on
the pedal until each preset footswitch LED blinks.