Source Audio Hot Hand 3 Universal Wireless Adapter - Manual (Page 13)

• Line 6 mode is a special setting for use with Line 6 effects
units and stompboxes. Note: Unlike most expression inputs,
this mode uses a normal mono (TS) guitar cable instead of a
stereo (TRS) type.
Status LEDs and troubleshooting
The ring and receiver both have LEDs to indicate status. The table
on this page describes the different ways the LEDs will appear. If the
LEDs are indicating a problem, use the table for troubleshooting.
Please note that when the directions say to “cycle the power”, you
should unplug the base station’s sensor cable and DC power supply,
turn the ring OFF, and start these directions from the beginning.
- Continued
Status LEDs and troubleshooting | 13
Normal
ON
1 2 3 4
OFF
Reverse
ON
OFF
Line 6
ON
OFF