Source Audio Hot Hand 3 Universal Wireless Adapter - Manual (Page 12)

12 | Notes on using multiple units / Configuring the expression output
Notes on using multiple units
The Hot Hand 3 Universal Wireless Effects Controller is designed to
accommodate simultaneous use of up to four ring/receiver pairs. The
receiver is programmed to lock on to the strongest signal, so to ensure
that your wireless ring is linked to the correct receiver, hold the ring
within a foot of the base station and press the ring’s ON/OFF button.
Once the ring has linked to the desired receiver, you can turn the ring
ON and OFF without breaking the connection. To reset the ring/receiv-
er link either disconnect the power or press and hold the CALIBRATE
button for two seconds.
Configuring the expression output
Since expression inputs and outputs are not standardized the Hot Hand
3 has a set of small switches that can be used to configure the Expres-
sion Output to work with a variety of third-party effects unit. There is a
small set of switches on the underside of the receiver unit. Depending
on your setup, you can adjust the switches as necessary by using a
ballpoint pen or similar small tool.
• Normal mode is the most common setting used by pedal
manufacturers, including Source Audio.
• Reverse mode is commonly used by Korg and some other
manufacturers.