Sonics GXL User Manual
Page 12
CABLE CONNECTIONS – For Models with 700 to 2200
Watts Power:
Located at the rear of the power supply are the cable connections as
illustrated below. (The interconnecting cables will be supplied with your
system.)
❶
J1, a round, 12-pin RF cable that connects the welding press or
converter to the power supply.
❷
J2, an actuation cable that connects the power supply to a trigger source
(press cable or external trigger source.) Refer to wiring diagrams in
Appendix.
❸
The power line cord that plugs into the appropriate electrical outlet.
Once these connections have been made, the power supply is ready for
operation. If applicable, be sure to consult your welding press instruction
manual to insure that all connections on the press side are correct, and
that the press is ready for operation.
Also located at the rear of the power supply are the following:
❹
J3 Linear Encoder
❺
J5 External I/O
➏
Fuse (0.5 amp - internal low voltage)
❼
Line fuse (based on requirements listed in “Power Specifications” table,
❽
Line fuse (based on requirements listed in “Power Specifications” table,
❾
J4 Serial Output
❾
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
I N S T R U C T I O N M A N U A L • M O D E L G X L P O W E R S U P P LY
11
❷
❶
❸
❺
➏
❼
❹
NOTE: Detailed wiring
diagrams are supplied
in the Appendix at the
back of this manual.
❽
Fan
NOTE: To see a list of
converters that can
be connected to the
power supply, see the
table on the following
page.
Go To Top Of Document