Solvline LemonIDE Ver 1.0c - Manual (Page 54)

LemonIDE TM
Chapter 7. Monitoring Tool
“kill” to finish the process. Make sure the process is killed.
Please note that the process list view refreshes every 10 seconds, so it may take a while for the finished process to
disappear from the list.
It might be the case that the process does not exist when you try to kill the process. If this is the case, you will be
prompted with the following message.
Select “Windows – Show View”menu to monitor views in LemonIDE Monitor.
7.3 Terminal
Remote execution and remote debugging on target system requires a terminal program.
A terminal program refers to a serial emulator and a telnet emulator in this case and LemonIDE supports both
emulators enabling remote execution & debugging of target system all in LemonIDE’s IDE.
Select “Windows” Æ “Show View” Æ “Other…” Æ “Terminal” Æ “Terminal”from LemonIDE’s title menu to
enable a terminal. Terminal will be created in “Message View” located on the lower part of LemonIDE.
New Terminal : Create a new terminal.
Connect : Connect to preregistered Target.
Disconnect : Terminate a connection.
Settings : Set Target connection information
In order to execute a terminal as an independent window outside of Message View, right click on terminal window’s
title menu bar and select ‘Detached”.
In “Message View”, on lower part of LemonIDE, select the newly created terminal, and click to set
connection environment.
View Title : Set terminal’s name
Connection Type : Select terminal to use (Serial, Telnet)
Image below shows configuration of a Telnet terminal(left) and a Serial terminal(right).
7-6