Solberg Inlet Vacuum Filters - Manual (Page 8)

Solberg Manufacturing, Inc., 1151 Ardmore Itasca, IL 60143 USA
Ph: 630.773.1363 Fax: 630.773.0727 Email: [email protected] Web: www.solbergmfg.com
Rev: MMVF-910
Page 8
SOLBERG
circumstances, the operator should avoid exceeding the manufacturer’s
recommended maximum pressure drop for their specific equipment.
A. Polyester Element: The polyester element may be washed in warm
soapy water, vacuumed, gently blown out or replaced. The element
should be dry before reinstallation. The element should be replaced after a
maximum of three cleanings.
B. Paper Element: The paper element may be lightly blown with low
pressure air. It is disposable and in most cases should be replaced with a
new element.
C. Polyurethane Prefilter: The prefilter may be washed as a sponge or
replaced to give the element a longer service life.
D. Epoxy Coated Wire Mesh and Stainless Steel Wire Mesh Elements:
Cleaning instructions similar to polyester, except mild solvents may be
used.
E. Activated Carbon Element: Not cleanable
F. Polypropylene Element: Cleaning instructions similar to polyester
G. Nomex Cloth Element: Cleaning instructions similar to polyester
If you are not confident that the integrity of the element was maintained during
cleaning, it is recommended that a new element be installed. Also, spare parts
such as gaskets, wing nuts and washers can be supplied upon request.
Section C
PROCEDURES
1. Installation.
A. Maximum inlet gas stream temperature for most Solberg inlet vacuum
filter products is 220°F / 105°C. Temperatures in excess of this could
cause damage to elements, media and elastomers.
B. Direction of flow is typically from the outside of the element to the inside of
the element. Most products have arrows indicating direction of flow on
inlet and outlet ports.
C. Ensure that pipe/flange connections are adequately sealed so the
potential for leaks is reduced to a minimum.
2. Disconnecting canister top from canister base.
A. ST/CT/Small CSL: Release wire-form clips or loosen wing nut on “claw”
bolts.