Solberg SLCR-SLCRT(Pg.2-9) - Manual (Page 6)

Solberg Manufacturing, Inc., 1151 Ardmore Itasca, IL 60143 USA
Ph: 630.773.1363 Fax: 630.773.0727 Email: [email protected] Web: www.solbergmfg.com
Page 6
A. Maximum operating temperature for most Solberg side channel blower
silencers is 275°F / 135°C. Temperatures in excess of this could cause
damage. High temperature products are available.
B. Ensure that pipe connections are adequately sealed so the potential for
leaks is reduced to a minimum.
2. Securing Silencer to Application Inlet or Outlet.
Place silencer on inlet or outlet connection and rotate to tighten. Note: Do NOT
over tighten!
3. Equipment Startup.
A. Be sure to read the instructions on installation as listed above before
starting equipment.
*WARNING*
If at any time the operator is unable to
verify the integrity of the silencer, the
factory or a regional representative should
be contacted prior to start-up.
B. Please check the listed steps prior to startup.
1. Check silencer to make sure it is securely tightened onto
inlet/outlet connection. See figure C.2.2
Figure C.2.1: Silencer and inlet/outlet connection. Figure C.2.2: Silencer in secured
position.