Solberg MiniFS(Pg.2-4) - Manual (Page 10)

Solberg Manufacturing, Inc., 1151 Ardmore Itasca, IL 60143 USA
Ph: 630.773.1363 Fax: 630.773.0727 Email: [email protected] Web: www.solbergmfg.com
Page 10
B. FS-(04, 05, 06, 07, 10, or 11): Reassemble housing top to base by
aligning tabs and turning into place.
6. Equipment Startup.
A. Be sure to read the instructions on installation or element replacement as
listed above before starting equipment.
*WARNING*
If at any time the operator is unable to verify
the integrity of the element or any housing
feature, the factory or a regional representative
should be contacted prior to start-up.
B. Please check the listed steps prior to startup.
1. Check element to make sure it is seated properly in housing
base.
*WARNING*
Failure to seat the element properly may result
in contaminant by-pass resulting in damage to
equipment.
2. Check housing to make sure the housing top is properly
secured to base. See procedure 5 and Figure C.5.1 for details.
Figure C.5.1: Housing tab alignment in sealed position.