Slant/Fin Line 30 - Manual (Page 13)

FILLER SLEEVES (cont’d)
1. When mounting the baseboard to the wall,
be sure the filler sleeve will overlap each
baseboard unit by at least
1 ⁄
2
”.
2. Slip in the back piece so that the bent
edge rests in the bottom channel of the
baseboard. Nail the back piece to the wall
to hold it in place.
3. Move both dampers to half-open position.
Hold the damper sleeve with the crimped
edge away from you. Hook it’s front edge
over the front edges of the dampers. Snap
the back edge of the sleeve into place by
pinching -- with thumb pressure on the
baseboard top panel and finger pressure
up under the back edge of the damper.
3A. (For Multi/Pak 80)
Move both dampers to
half open position.
Hook the damper
sleeve’s top edge over
the top edge of the
dampers. Press down
on the sleeve and
snap the bottom edge
into place.
4. Hook the sharp angle of the top sleeve
over the front edge of the baseboard’s top
panel. Press down on the back edge until
the sleeve snaps into place.
5. Replace baseboard front covers. Hook the
front sleeve’s top edge over the front cov-
ers and snap the bottom edge into place.