SIG SAUER SIG50 - Manual (Page 37)

when it counts ™
www.sigsauer.com 37
6.3 Recovery from failure to fire
if the rifle does not fire after completing 6.1 or 6.2:
1. unload, and clear the rifle;
2. insert a fresh magazine;
3. Slide bolt forward to chamber a round; and
4. attempt to fire the rifle.
if THe rifle failS To fire afTer aTTeMPTing all of THe aBoVe, THe rifle SHould Be reTurned To Sig Sauer, inc.
for eValuaTion By a facTory Trained TecHnician.
7.0. field strip disassembly
1. unload and clear the rifle per section 5.0.
2. Point the rifle in a safe direction.
3. Move the safety lever to the rear (Safe) position.
4. avoid touching the trigger while moving the safety lever.
5. raise the bolt handle.
6. Pull the bolt all the way to the rear.
7. depress the bolt stop release.
8. as bolt stop release is depressed, slide the bolt from the rifle. The butt stock must be removed to remove the bolt.
The buttstock must be removed to allow the bolt to be removed from the receiver for field strip and cleaning.