Scientech PDA User Manual
Page 20
20 of 27
9.
The “Phone Number” window will appear.
10.
Click the down arrow in the “Connect using” box.
11.
Select the correct Com port which is connected to your modem. Normally this will be “Direct to
Com 1”.
12.
Click on “OK”. The “COM1 Properties” window will appear.
13.
Enter the following parameters into the port settings: (These parameters are the default parameters
of the Scientech balance when it was sent to you. If you changed the balance default parameters,
you must change them back to what is shown below. See your balance instruction manual for
guidance.)
A.
Bits per second
9600
B.
Data
bits
7
C.
Parity
None
D.
Stop
bits 1
E.
Flow
control
None