Handle trim installation (2) – Santec 9520KT User Manual
Page 6

0 6
9520KL,KR, KT _ _
From underneath the sink or counter, screw the valve body mounting
hardware pieces back onto the valve body. First the washer, then the
brass lock nut.
Align the levers or cross handles properly against the spout. Tighten the
brass lock nut with a plumber’s wrench until it secures the valve body
screwdriver.
avoid leakage.
Connect and tighten the inlet hoses to the supply lines.
After the connections have been made, remove the aerator housing by
unscrewing it counter-clockwise. Turn on the water supply at the valves
beneath the sink or counter and check for leakages at all joints. If water
leaks from any of the connections, tighten the connection until the
leakage stops.
If no leakage, slowly turn the handles to the full open position and let
to the ceramic cartridges caused by debris in the supply lines.
H a n d l e Tr i m
Handle Trim Installation (2)
Inlet Hoses
Aerator
Housing