Santec 4020PL - Manual (Page 4)

INSTALLATION INSTRUCTIONS
PAGE 04
C
- Position the drain tube so the side hole in the pop-up faces you.
Place the drain plug into the drain tube, align its bottom hole with the side
hole.
- Place the short end of the ball rod into the side hole of the drain tube and
through the hole in the drain plug and tighten the ball rod nut so the ball rod
moves freely. NOTE: Do not over tighten.
D
- Rotate the pop-up so the ball rod faces the back wall and tighten the lock
nut giving it an extra 1/4 turn. Hand tighten the nut at the connection with
P-trap. Test the rod to make sure it raises and lowers freely.
- Slip your faucet's pop-up lift rod through the holes at the top of the lift rod
strap and hand tighten the thumb screw. Push the ball rod down so the
drain plug is in the up position.
- Slip the one leg of the ball rod clip onto the ball rod and then slide the lift
rod strap onto the ball rod using the nearest hole. Then slide the second
leg of the clip onto the rod. Test the pop-up for smooth operation and
adjust the strap if necessary.
4.
FLUSH THE LINE
A
- After all the connections have been made, remove the aerator housing (18)
basket (17) and washer (16).
- Turn on the water on both hot and cold sides and flush the lines for 45 seconds.
- Turn off the water and reinsert the washer (16), basket (17) and Housing (18).
- Turn on the water and check for leakages at all joints. If water leaks from any of
the connections tighten the connection until the leakage stops.
Santec Inc.
3501 Challenger Street, Torrance, CA 90503
Tel: (310) 542-0063 Fax (310) 542-5681
www.santecfaucet.com
08/04
SANTEC SANTEC
INLET HOSE INLET HOSE
SANTEC SANTEC
INLET HOSE INLET HOSE
TO THE COLD SUPPLY LINE TO THE HOT SUPPLY LINE
C
D
ball rod
drain plug hole
lift rod strap
ball rod clip
thumb screw
4020PL
A