Santec 4020PL - Manual (Page 2)

INSTALLATION INSTRUCTIONS
1.
SPOUT INSTALLATION
A
- Remove the tee connector (11), spout mounting hardware (4) and tee
connector washer (12) from the bottom of the spout assembly. Apply a
ring of silicone caulking around the center hole on the top of the sink.
(Do not use plumbers' putty which can damage the spout finish).
- From the top of the deck, insert the spout's threaded shank with the lift
rod (19) and knob (14) through the center hole of the sink.
B
- Slip the spout mounting hardware (4) back onto the spout. First the
notched rubber washer, then the notched metal washer, wing nut and
the last the brass lock nut. Hand tighten the lock nut.
- Attach the lift rod extension (21) to the lift rod (20).
Make sure the lift rod operates smoothly. Adjust it if necessary.
C
- Align the spout and secure the spout to the counter by tightening the
2 screws on the wing nut.
- Place the tee connector washer (12) into the tee connector (11) and
thread on the tee connector at the end of the spout shank.
Tighten to seal.
FLUSH BOTH SUPPLY LINES BEFORE INSTALLATION
.
AFTER FLUSHING , SHUT OFF BOTH SUPPLY LINES.
MINIMUM HOLE SIZE FOR THE SPOUT AND HANDLE TRIM IS 1 ¼ ” AND MAXIMUM OF 1 ½ ”
2.
HANDLE TRIM INSTALLATION
HANDLE TRIMS ARE READY FOR SIMPLE DROP IN INSTALLATION.
DO NOT DISASSEMBLE.
A
- Remove the valve body mounting hardware (13) from the valve body.
- Make sure the handle with the “cold” blue label (8) is installed at the right side
of the spout (looking from the front) and the handle with the “hot” red label (7)
at the left side of the spout.
- Apply a ring of silicone caulking around the handle hole on the sink top.
(Do not use plumbers' putty which can damage the finish of the faucet).
- Slip the valve body’s flexible hoses from the top of the sink or counter through
the appropriate hole next to the spout. Aim the tee connecting hoses (9)
toward the tee connector (11).
Notched rubber washer
Notched metal washer
Wing Nut
Brass lock nut
SANTEC SANTEC
rubber washer
rubber washer
Lift Knob
Lift Rod
Lift Rod Extension
4020PL
Lift Rod
C
Tee connector & washer
Brass lock nut
B
A
A
PAGE 02