Santec 4020PL - Manual (Page 3)

B
- Align the handle lever properly with respect to the spout.
- From under the basin or counter, hand tighten the brass lock nut and
fiber washer to the valve body against the counter.
C
- Secure the valve body by tightening the screws attached to the lock nuts.
D
- Loop and connect the flexible hoses (8) to the tee (11).
- Tighten the nuts provided at the of the hose to avoid leakage.
- Connect and tighten the Inlet hoses (9) to the supply lines.
Use 1/2” IPS faucet connections, or 3/8” copper piper using compression
fitting system.
3.
POP-UP DRAIN INSTALLATION
A
- Remove the drain flange and drain plug from pop-up assembly.
- Do not remove the gasket, washer and lock nut.
B
- Apply a ring of silicone caulking underneath the drain flange.
Do not use plumbers' putty.
- Insert the threaded end of the assembly up from the under the sink.
Completely thread the drain flange onto the top of the drain tube.
- Tighten the locknut from under the sink.
INSTALLATION INSTRUCTIONS
SANTEC SANTEC
Water supply
line
Water supply
line
SANTEC SANTEC
INLET HOSE INLET HOSE
SANTEC SANTEC
Fiber washer Fiber washer
Brass lock nut Brass lock nut
B
C
D
A B
4020PL
PAGE 03
Drain Plug
Drain Flange
Lift Rod Strap
Ball Rod
Drain Tube
Ball Rod Nut
Ball Rod Clip
Thumb Screw
Lock Nut
Washer
Gasket
Side hole
Liift Rod Extension
Lift Rod & Knob