Rogue Engineering 1950-250 - Manual (Page 9)

Modbus/SDI-12 Gateway User Manual Page 9 of 12
Last Updated: August 20, 2013
Appendices
This information is provided for advanced users only, and allows for configuration of units
without using the provided Windows software. Typical users do not need this information.
Appendix A - SDI-12 Configuration Register Map
The following register is valid for firmw3are version 5400-362-03 for the SDI-12/Modbus
Translator hardware. All configuration data is accessed via Modbus functions 3, 6, and 16 (holding
registers). The unit will respond to commands for any Modbus address for this range of registers.
Modbus Registers
Item Name Register # Length
Reserved 10000 3000
Configuration Name 13000 40
Last Modified 13040 4
Modbus Direction 13044 1
Modbus Address 13045 1
Modbus Baud Rate 13046 1
SDI Power 13047 1
Poll Interval 13048 1
Power Up Delay 13049 1
Number of Commands 13050 1
Auto sequence Option (internal use) 13051 1
Reserved 13052 8
Firmware Version Number 13060 1
Firmware Revision Number 13061 1
Reserved 13062 37
Configuration Set (internal use, write 1 to implement newly written
configuration) 13099 1
Command 1 Sensor Address 13100 1
Command 1 Sensor Poll Interval 13101 1
Command 1 First Input or Holding Register; actual register
(protocol address) is one less than this number 13102 1
Command 1 13103 1
Command 1 First Value 13104 1
Command 1 # of Values 13105 1
Command 1 CRC Option 13106 1
Command 1 Data Format 13107 1
Command 1 Word Order 13108 1