Cadillac 2010 SRX Crossover - Manual (Page 225)

Infotainment System 6-59
4. Continue entering digits until the
number to be dialed is complete.
After the whole number has
been entered, say “Dial”. The
system responds “OK, Dialing”
and dials the number.
. If an unwanted number is
recognized by the system,
say “Clear” at any time to
clear the last number.
. To hear all of the numbers
recognized by the system,
say “Verify” at any time.
Using the Call Command
1. Press
b
/
g
.
. For vehicles without a
navigation system, the
system responds “Ready”
followed by a tone.
. For vehicles with a
navigation system, the
system responds with a
tone. After the tone say
“Hands Free”. The system
responds “Ready” followed
by a tone.
2. Say “Call”. The system responds
“Call using .
Please say the name tag”
followed by a tone.
3. Say the name tag of the person
to call.
. If the system recognizes
the name tag it responds
“OK, calling, ”
and dials the number.
. If the system does not
recognize the name tag, it
confirms the name tag
followed by a tone. If the
name tag is correct, say
“Yes”. The system responds
with “OK, calling, tag>” and dials the number.
If the name tag is not
correct, say “No”. The
system will ask for the
name tag again.
Once connected, the person called
will be heard through the audio
speakers.
Using the Re‐dial Command
1. Press
b
/
g
.
. For vehicles without a
navigation system, the
system responds “Ready”
followed by a tone.
. For vehicles with a
navigation system, the
system responds with a
tone. After the tone say
“Hands Free”. The system
responds with “Ready”
followed by a tone.
2. After the tone, say “Re‐dial”. The
system responds “Re‐dial using
” and dials the
last number called from the
connected Bluetooth phone.
Once connected, the person called
will be heard through the audio
speakers.