Cecilware ESP1 - Manual (Page 8)

Output Volume Setup
a. Turn the output volume setup switch ON (1) and press the PROG (setup) button.
b. The output LEDs should be lit, indicating the machine is in setup mode.
c. To configure key 1, press the key 1 button, which should light LED 1 and switch off all
other LEDs. Once desired setup parameters have been set, press key 1 again to
confirm and exit key 1 setup.
d. At this point, LED 1 should be off and LED's 2, 3 and 4 should be lit.
e. Repeat steps (b) through (d) to set up keys 2, 3 and 4, respectively.
f. The left set(s) of keys will mirror the value settings in the set of keys to its immediate
right. Repeat steps (b) through (e) if different output volumes are desired for different
cup compartments.
g. After completing setup, turn the output volume setup switch OFF (1) to return the
machine to normal operational mode.
4-5 Automatic Reverse Flushing
a. Press any key simultaneously to start automatic reverse flushing. Keys 2-4 in the
control panel will start flashing and start automatic reverse flushing from the right
output system to the left.
b. The default is 10 cleaning cycles.
c. Flush the second output system after flushing the first output system. Or press the 3rd
key to skip to the next output system, System will stop automatically after finish all the
reverse flushing.
4-6 Stopping the Machine
a. After cleaning the machine, remove all liquids and solid matter from the water tray.
b. Turn off the power (turn power switch to position 0).
c. Open steam knob to release steam flow. Do not place any liquid under the steam tube
during this process in to avoid system contamination.
5. Cleaning and Maintenance
5-1 Cleaning the Machine Body
Wipe machine exterior with soft, slightly dampened cloth daily before starting operations.
8
LED Setup Button
Output Keys