Reliable EV1 - Manual (Page 16)

14
fig. 7
E
fig. 8
FILLING THE DUST COLLECTING
TANK WITH WATER (FIG. 7–8)
To fill the tank with the water necessary for
dust removal, proceed as follows:
t %JTDPOOFDUUIFNBDIJOFGSPNUIFQPXFS
supply.
t Remove the male plug of the flexible hose
from the machine.
t Remove the dust collecting tank.
t Pull out the lower part of hook E and raise
the tank cover.
t 'JMMXJUIXBUFSVQUPUIFMFWFMJOEJDBUFE
inside the tank (white mark).
t Reposition the tank on the machine
making sure it is properly placed until
limit stop.
t Re-connect the plug of the flexible hose
to the machine (fig. 3-4).
A wrongly fitted tank will result in a poor
suction.
CONNECTION TO THE
POWER SOURCE
Before connecting to the power power source
check that:
tUIFWPMUBHFBOEQPXFSSBUJOHTPGUIF
machine printed on the data plate located
under the machine and indicated in the
paragraph “Technical characteristics”, are
compatible with the electrical system;
tUIFFMFDUSJDBMTZTUFNUPXIJDIUIFNBDIJOF
will be plugged complies with the norms
and has a safety switch for fault current
that does not exceed a value of 20 amps;
tUIFFMFDUSJDBMPVUMFUUPXIJDIUIFNBDIJOF
must be plugged has a rating of 16 A and
it is properly grounded;
tUIFQPXFSDPSEIBTOPEBNBHFPS
abrasions and is in perfect condition.
Never connect the plug to the power supply if
it is wet or if you have wet or damp hands.
Never pull the electrical cord to unplug the
socket. Instead, take the plug between
forefinger and thumb and pull slowly and
firmly.
If the power cord is damaged, it must be
replaced by qualified personnel of the
Technical Service Centre.
USE OF THE MACHINE
CAUTION
ATTENTION
IMPORTANT
CAUTION
ATTENTION
IMPORTANT
CAUTION
ATTENTION
IMPORTANT
CAUTION
ATTENTION
IMPORTANT
CAUTION
ATTENTION
IMPORTANT