To enter remote start mode – Ram Trucks 2015 Chassis Cab Commercial - Diesel Supplement User Manual
Page 146
![background image](/manuals/709191/146/background.png)
To Enter Remote Start Mode
Push and release the REMOTE START button on
the RKE transmitter twice, within five seconds.
The parking lights will flash and the horn will
chirp twice (if programmed). In cold ambient
temperature conditions, the diesel vehicle may delay crank
up to 30 seconds for the fuel and grid heater. Once the
vehicle has started, the engine will run for 15 minutes or
75 seconds in extreme cold and high elevation.
NOTE:
• The park lamps will turn on and remain on during
Remote Start mode.
• For security, power window and power sunroof op-
eration (if equipped) are disabled when the vehicle is
in the Remote Start mode.
• The engine can be started two consecutive times (two
15-minute cycles) with the RKE transmitter. However,
the ignition switch must be cycled to the ON position
before you can repeat the start sequence for a third
cycle.
To Exit Remote Start Mode Without Driving The
Vehicle
Push and release the REMOTE START button one time or
allow the engine to run for the entire fifteen minute cycle.
NOTE:
To avoid unintentional shut downs, the system
will disable the one time push of the REMOTE START
button for two seconds after receiving a valid Remote
Start request.
144 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE