Ram Trucks 2014 ProMaster Commercial - User Guide - Manual (Page 10)

KEY FOB
Locking And Unlocking The Doors
• Press the LOCK button once to lock all
the doors.
• Press the UNLOCK button once to
unlock the driver’s door only and twice
within five seconds to unlock all the
doors.
All doors can be programmed to unlock
on the first press of the UNLOCK button.
Refer to the Owner Manual on your DVD
for further information.
SEAT BELT
Be sure everyone in your vehicle is in a seat and using a seat belt properly.
• Position the lap belt across your thighs, below your abdomen. To remove slack in the
lap portion, pull up a bit on the shoulder belt. To loosen the lap belt if it is too tight,
tilt the latch plate and pull on the lap belt. A snug belt reduces the risk of sliding
under the belt in a collision.
• Position the shoulder belt on your chest so that it is comfortable and not resting
on your neck. The retractor will withdraw any slack in the belt.
A shoulder belt placed behind you will not protect you from injury during a collision.
You are more likely to hit your head in a collision if you do not wear your shoulder belt.
The lap and shoulder belt are meant to be used together.
A belt that is too loose will not protect you properly. In a sudden stop you could move
too far forward, increasing the possibility of injury. Wear your seat belt snugly.
A frayed or torn belt could rip apart in a collision and leave you with no protection.
Inspect the belt system periodically, checking for cuts, frays, or loose parts. Damaged
parts must be replaced immediately. Do not disassemble or modify the system. Seat
belt assemblies must be replaced after a collision if they have been damaged (bent
retractor, torn webbing, etc.).
Key Fob
1 — Cargo Doors
2 — Unlock
3 — Lock
GETTING STARTED
8