Ram Trucks 2009 3500 - Quick Reference Guide - Manual (Page 11)

Wipers
Pull lever for
high Beams
Push
Washer
turn signals/wiper/washer/high beaMs leVer
TURN siGNALs/LANE CHANGE AssisT
• Tap the lever up or down once and the turn signal (right or left)
will flash three times then automatically turn off.
WiPERs
intermittent, Low and High Operation
• Rotate the end of the lever to the first detent position for one of five
intermittent settings, the second detent for low wiper operation and
the third detent for high wiper operation.
Washer
• Push in on the end of the lever and hold for as long as spray is desired.
HiGH bEAMs
• Pull the lever toward you to activate the High Beams.
• A High Beam symbol will illuminate in the cluster to indicate the
High beam lights are on.
tilt steering wheel
• The control handle is located behind the steering wheel at the
end of the steering column.
• To unlock, pull the handle toward you.
• Move the steering wheel up or down to the desired position,
then push the handle away from you to lock into place.
175474_09_RAM2500_3500_QRG.indd 12 11/5/08 4:41:07 PM