PYRAMIDA KH 60 Rustico v.2 - Manual (Page 32)

33
The works on maintenance should be performed on
cooking hood with the purpose of maximal performance and
effectiveness of its operation during the life time.
The cooking hood should be discon-
nected from the power network at
works connected to the maintenance
on cooking hood.
Regularly perform following actions at maintenance:
- Regularly remove all food debris and fat from the lower
surface of the cooking hood and from aluminum fat
filters. An excessive fatness can lead to fire!
- Wipe the external surfaces of the cooking hood with the
humid, good squeezed flannel tissue.
- Use special fluids creating the protective film for handling
the surfaces made of stainless steel.
- Do not use the abrasive agents and solvents.
- Verify the conditions of the air duct of cooking hood and
ventilation channel, clean them at necessity!
Carbon filters can be purchased in retail
outlets or authorized service centers.
PRODUCT MAINTENANCE
In the extractor fan lighting lamps of type Е14 are used,
their power is not more that 40 W. Replacement of lamps is
made in the following order:
- Make sure that cooking hood is disconnected from power
network before lamps replacement; wait until lamps will
cool down.
- press the filter lock and take off the fat filter;
- Unscrew an old lamp from the holder and screw the new
one;
- press the filter lock and install the fat filter into the cooking
hood.
BACKLIGHTS REPLACEMENT
E14 40Вт
EN
32
1. Mount the back surface
of the cooking hood to
the wall by the means of
the screws with dowels
from the installation kit.
2. Install the adapter of air
duct onto the cooking
hood by the means of
screws with use of seal
from installation kit.
3. Connect the air duct
to the adapter of the
cooking hood. Take out
another end of an air duct
to the air-shaft. Ensure
that chinks are absent in
the connections.
4. Install casings of an air
duct and fix them with
screws from installation
kit.
INSTALLATION OF EXTRACTOR FAN TO THE WALL
Mounting points
Mounting
points