Clarke BEXT 300HV - Manual (Page 7)

Page 16 Clarke ® B EXT ® -100, 100H 150H, 300HV Operator's Manual
VACUUM SWITCH (1 ): The vac switches illuminate when turned
on.
PUMP SWITCH (2): This switch will illuminate when the pump
is on.
5. If the extractor removes an excess amount of foam
from the carpet, add a de-foamer such as Clarkare ®
De-foamer Concentrate to the recovery tank. The
amount needed will vary according to the amount of
detergent already in the carpet.
CAUTION: To prevent damage, use a water-based de-
foamer rather than an oil-based de-foamer.
CAUTION: Do not leave the extractor or other cleaning
machines or tools on the carpet when not
in use. Cleaning solution in the machines
and tools can leak onto the carpet and
cause light spots or stains.
NOTE: To order Clarkare ® Extractor Concentrate, order
part no. 398421. To order Clarkare ® Defoamer,
order part no. 398420.
For instructions for preparation and operation of your floor
tool, read the instruction sheet given with your floor tool.
1 2
VAC PUMP
Figure 4
B EXT ® -100 Control Panel
B EXT ® -100H Control Panel
CIRCUIT LOCATOR (1): When this light is on, it indicates that cord
#2 is on a separate line from cord #1. Cord #2 supplies voltage
to the heater allowing it to heat to the proper temperature range.
VACUUM SWITCH (2): The vacuum switch will illuminate when
the vacuum motor is turned on.
PUMP SWITCH (3): This switch will illuminate when the pump
is on.
HEAT SWITCH (4): The heat switch will illuminate when it is
activated and will turn the heater on.
2 3 4
VAC PUMP HEAT
Figure 5
1
LOCATOR