PS Engineering PM1200 Installation Manual - Manual (Page 6)

March 2013 Rev. 12 Page 6 200-196-0104
4.725
A A
A
5.48
4.0 3.50
Ø0.136
PM1200 Remote P/N 11961
installation drawing (not to
scale)
Section 4
Warranty and Service
4.1 Warranty
In order for the factory warranty to be valid, the instal-
lations in aircraft must be accomplished by an FAA- certi-
fied avionics shop and authorized PS Engineering dealer. If
the unit is being installed by a non-certified individual a
factory-made harness must be used for the warranty to be
valid.
PS Engineering, Inc. warrants this product to be free
from defect in material and workmanship for a period of
one year from the date of sale. During this one year war-
ranty period, PS Engineering, Inc., at its option, will send a
replacement unit to the PS Engineering dealer, if the unit
should be determined to be defective after consultation with
a factory technician. PS Engineering will not ship to the
end user under warranty, unless authorized by the dealer.
This warranty is not transferable. Any implied warran-
ties expire at the expiration date of this warranty. PS Engi-
neering SHALL NOT BE LIABLE FOR INCIDENTAL OR
CONSEQUENTIAL DAMAGES. This warranty does not
cover a defect that has resulted from improper or unreason-
able use or maintenance as determined by us. This warranty
is void if there is any attempt to dissemble this product
without factory authorization. This warranty gives you spe-
cific legal rights, and you may also have other rights which
may vary from state to state. Some states do not allow the
exclusion of limitation of incidental or consequential dam-
ages, so the above limitation or exclusions may not apply to
you.
4.2 Factory Service
The PM1200 is covered by a one-year limited war-
ranty. See warranty information.
Call PS Engineering, Inc. at (865) 988-9800 before you
return the unit. This will allow the service technician to pro-
vide any other suggestions for identifying the problem and
recommend possible solutions.
After discussing the problem with the technician and
you obtain a Return Authorization Number, ship product
to:
PS Engineering, Inc.
Attn: Service Department
9800 Martel Road
Lenoir City, TN 37772
(865) 988-9800 FAX (865) 988-6619.
NOTE:
PS Engineering is not responsible for units shipped US
Mail.
If no method of payment is provided, the units will be re-
turned COD. If no RMA or description of problem is present, the
shipment will be refused.