PS Engineering PMA7000B Installation Manual User Manual
PS Engineering Accessories communication
Table of contents
Document Outline
- Section I GENERAL INFORMATION
- Section II - Installation
- GENERAL INFORMATION
- Unpacking and Preliminary Inspection
- Equipment Installation Procedures
- Cable Harness Wiring
- Noise
- Existing KMA-24 Installation
- Existing PMA6000 installations
- Power
- Communications Push-to-Talk
- Audio Panel interface
- Com 3 Duplex (TEL) Function for Cell Phones
- Transmit Interlock
- "Swap" Mode
- Backlighting
- Unswitched inputs
- PA Mute (J1, Pin 18)
- Public Address Function (J2, Pin 18)
- Control Output (J2, Pin A)
- Intercom wiring
- Entertainment Input
- PMA7000B Intercom expansion (J2, Pins P, S, and C)
- Marker Beacon Installation
- Adjustments
- Communications Antenna Installation Notes
- PMA7000B Pin assignments
- Post Installation Checkout
- Unit Installation
- Cellular Interface Checkout
- Final Inspection
- Section III OPERATION
- Section IV- Warranty and Service
- Appendix A External PTT Hook Up
- Appendix B – PMA 7000B Installation Drawing
- Appendix C Bottom Connector Interconnect
- Appendix D Top Connector Interconnect
- Appendix E- Instructions for FAA Form 337 and continuing ai worthiness
- Appendix F RTCA DO160C (EUROCAE ED-14) Environmental Qualification Form
- Cross reference for Bendix/King KMA26
- Cross-reference for GMA340