Pro Boat PRB3600 - Manual (Page 9)

9
Use a #1 Phillips screwdriver to remove
the screw from the rear cover.
Carefully lift the rear cover at the rear. A
tab holds the cover at the front, so pull
the cover rearward to release the tab. Set
the cover aside in a safe place.
The torpedos are attached to the hull
using a tab at the front and a piece
of rubber tubing at the rear. Once the
torpedos are in place on the hull, you will
need to slide the tubing onto the threaded
studs from inside the hull.
Place the tab on the front of the torpedo
into the slot on the hull. Rotate the
torpedo into position, making sure you
keep the torpedo close to the hull to
prevent damaging the tab.
Accessory Installation