beautypg.com

Pro Boat PRB3300S User Manual

Page 9

background image

9

EN

The ESC in your Blackjack 26 SS

Brushless EP is pre-programmed from the

factory. The programming is set for Ni-MH

batteries as shipped with your

Blackjack 26 SS.
A programming module (PRB3311) is

available to change the programming

of your speed control. Settings include

Ni-MH or Li-Po batteries, cutoff voltage

settings, cutoff type, brake on or off,

motor timing and throttle curve.

CAUTION: It is imperative

that you do not attempt to use

Li-Po batteries in the Blackjack 26

SS Brushless unless it has been

properly programmed or serious

damage to the batteries and

electronics may occur.

Test the radio system for proper

operation and then carefully place the

boat in the water. Pilot the boat at slow

speeds, staying close to the shoreline

to ensure you have good control and

that the boat is functioning correctly. Be

certain to avoid all objects in the water at

all times.

Once you feel comfortable with the

control of your boat, it is safe to go

further away from the shoreline and at

faster speeds. When you notice the boat

beginning to lose speed, bring the boat

back to shore. It will be necessary to

allow the electronic components to cool

down and to replace or recharge the

battery before heading out again.

Section 7: Testing Your Boat in the Water

NOTICE: Do not turn off the

transmitter first or the receiver

may pick up stray signals and run

out of control.

Section 8: Speed Control Programming

Before and at the end of each run, make

sure all screws are tight and the propeller

is free from any entanglement.

Section 9: Maintenance