Pro Boat PRB2250 - Manual (Page 6)

Section 7: Starting the Engine
6
Section 6: Fuel/Oil Mixture
Parts Needed
Ratio Rite ™ measuring cup
Unleaded gasoline
Zenoah
® 2-stroke oil
Step 2. Remove the fuel tank cap and fill the fuel tank with
the gasoline and oil mixture. Use a funnel to prevent spills.
If you do spill, be certain to immediately wipe it up with a
clean towel or rag. Step 1. Mix gasoline and 2-stroke oil (ZEN20001) at a mixing
ratio of 32 : 1 (gas to oil) using the Hangar 9
® Ratio Rite
Mixing Cup (HAN3101).
Step 1. Read the included Zenoah ® G23 marine engine
manual thoroughly to become familiar with the proper care
and operation. Do not attempt to operate this engine until
you have read the engine manual thoroughly.
Step 2. Turn the radio system on (transmitter first, then
the receiver.)
Step 3. To start the engine, push the priming bulb located on
the carburetor three to four times to prime the engine. If the
engine is warm, there should be no need to prime the engine.
Step 4. Open the throttle trim to an approximate position of
1/3 to 1/2 open. (See radio manual.)