Pro Boat PRB07000 - Manual (Page 11)

11
EN
Ragazza
Troubleshooting guide
problem possible Cause Solution
Boat does not respond
to the transmitter
Boat receiver is not bound
to the transmitter
Bind the receiver to the transmitter
Low or no power
Replace/recharge batteries
Ensure connections are secure and powered on
Fouled or broken sails, lines or servo Straighten, tighten or replace damaged parts
Boat moves too fast or
too slow for the wind
and water conditions
Rigging may be worn Repair or replace damaged parts
Sails may be adjusted too tight
Loosen or adjust the sail rigging for wind
and water conditions
Steering rate incorrect on the transmitter
for the wind and water conditions
Adjust the steering rate
Vegetation or other obstacles block the
rudder, keel or sails
Remove boat from the water and obstacles
Boat tends to turn one
direction
Sails are not centered
Center and adjust the sails and control
lines for the wind and water conditions
Rudder is not centered Adjust or repair rudder, connectors or servo
Boat tends to drift
Sails are not centered
Center and adjust the sails and control
lines for the wind and water conditions
The rigging is worn or broken Repair or replace damaged rigging
Rudder is not centered Adjust or repair rudder, connectors or servo
Boat tends to dive in the
water or takes on water
Sails are rigged too high or low
on the mast
Adjust the tightness of the rigging at
the top corner and bottom of each sail
Sails are tied too tight Loosen lines
The boat hull is not completely closed
Dry out the boat and ensure the hatch is fully
closed on the hull before returning the boat
to the water
Winch does not respond
to transmitter, while
rudder does
Winch servo is disconnected Connect servo to receiver
Winch, servo, line or other parts are
blocked or damaged
Repair or replace parts
Servo travel is too low Adjust travel
Trim is incorrect Adjust winch line or transmitter trim
Boat will not Bind (during
binding) to transmitter
Transmitter is too near boat during
binding process
Move powered transmitter a few feet from
boat, disconnect and reconnect battery to boat
Boat or transmitter is too close to large
metal object
Move boat or transmitter away from large
metal object
Bind plug is not installed correctly
Install bind plug in bind port and bind boat to
transmitter
Low or no power
Replace/recharge batteries
Ensure connections are secure and powered on
Boat will not connect
(after binding) to
transmitter
Transmitter is too near boat during
connecting process
Move powered transmitter a few feet from
boat, disconnect and reconnect battery to boat
Boat or transmitter is too close to large
metal object
Move boat or transmitter away from large
metal object
Bind plug is left installed in bind port
Rebind transmitter to boat and remove bind
plug before cycling power
Boat battery/Transmitter battery charge
is too low
Replace/recharge batteries
Transmitter may have been bound to a
different model
Bind boat to transmitter
Controls reversed Transmitter settings are reversed
Perform the Control Direction Test and
adjust controls on transmitter appropriately