PRG Mbox Director User Manual v3.7 - Manual (Page 53)

MBOX ® DIRECTOR USER MANUAL 47
To delete a loop:
Step 1. Right-click on required scene.
Step 2. At pop-up menu, select Delete.
To delete a link:
Step 1. Right-click on link in Scene List.
Step 2. At pop-up menu, select Delete Link.
Implicit Loops
Loops can also be "implied" by using a combination of timecode and autofollow times. For example, if an autofollow
time is running and the next scene in the Scene List has a timecode value greater than the current timecode, then it
will loop back to the last timecoded scene in the list.
Example configuration:
In the above example, the Saturate, Saturate2, and Saturate3 scenes all have an autofollow time of 2 seconds, while
the Cartoon scene has a timecode 30 seconds later. In this case, the Saturate, Saturate2, and Saturate3 scenes will
loop for 30 seconds until the Cartoon timecode is reached, at which time the sequence will advance to the Cartoon
scene.
Note that when looping back to the Saturate scene, timecode continues to run forward. Timecode does not reset to
01:00:05:00 each time through the loop.
To remove the loop, simply clear Saturate's autofollow. The show will advance to Saturate2, then to Saturate3, and
then advance normally to Cartoon when its timecode is reached.
The Scene List is not automatically sorted by timecode, so it can be edited in any order. However, it is best to
keep the scenes ordered by timecode, so that when a loop is insert, it's easier to visualize the progression
through the show.