Travel systems – phil&teds alpha User Manual
Page 24
Instructions
TRAVEL SYSTEMS
This child seat can be used as a travel system in
conjunction with selected strollers
Installing:
Having correctly attached an appropriate car seat adapter
(sold separately) to your stroller, test that the child seat is
fully attached by pulling the child seat up and forward; it
should not come free from the car seat adaptor.
Removing the child seat:
Red release levers are located on both sides of the child
seat, immediately above the connector points (as shown).
Lift up on both levers then lift the child seat off the stroller
using the carry handle.
See also other documents in the category phil&teds Products for children:
- classic v2 (60 pages)
- navigator (legacy model) (58 pages)
- navigator (68 pages)
- verve pre-2014 (58 pages)
- smart (42 pages)
- promenade (76 pages)
- sub4 jogger (28 pages)
- S4 USA & AUS (28 pages)
- vibe 2014 (72 pages)
- peanut (62 pages)
- snug (30 pages)
- vibe (19 pages)
- smart (pre-2013) (49 pages)
- S3 - USA (15 pages)
- sport v2 (13 pages)
- sport v1 (24 pages)
- e3 buggy (24 pages)
- e3 twin buggy (20 pages)
- espresso buggy (4 pages)
- kiwi explorer buggy single & double (6 pages)
- traveller (pre-2013) (43 pages)
- T2 travel cot (12 pages)
- kiwi traveller cot (2 pages)
- highpod (42 pages)
- metoo (22 pages)
- lobster (40 pages)
- airlight (32 pages)
- emotion (32 pages)
- parade (28 pages)
- metro 2014 (32 pages)
- escape 2014 (36 pages)
- metro v2 2009 (42 pages)
- escape v2 2009 (10 pages)
- metro v1 (12 pages)
- escape v1 (12 pages)
- pepe v1 (12 pages)
- bebe hs (4 pages)
- bebe (5 pages)
- quest (20 pages)
- optimum (44 pages)
- evolution (26 pages)
- cocoon genius (26 pages)
- columbus (10 pages)
- tott v1 (8 pages)