Securing the child in child restraint – phil&teds alpha User Manual
Page 18
Instructions
SECURING THE CHILD IN CHILD
RESTRAINT
5a
Press the adjuster button on the front center of the seat
and pull on both shoulder straps to loosen the harness.
5b
Press the red button on the buckle to release the
shoulder straps and move them to the side.
5c
Place child’s bottom on the seat and the child’s back
flat against the back of the child restraint. This will
increase the child’s comfort and allow the harness to
properly secure the child. Slide shoulder straps over the
child’s shoulders (5c). Make sure the harness is at or
below the top of the child’s shoulders.
5a
5b
5c
See also other documents in the category phil&teds Products for children:
- classic v2 (60 pages)
- navigator (legacy model) (58 pages)
- navigator (68 pages)
- verve pre-2014 (58 pages)
- smart (42 pages)
- promenade (76 pages)
- sub4 jogger (28 pages)
- S4 USA & AUS (28 pages)
- vibe 2014 (72 pages)
- peanut (62 pages)
- snug (30 pages)
- vibe (19 pages)
- smart (pre-2013) (49 pages)
- S3 - USA (15 pages)
- sport v2 (13 pages)
- sport v1 (24 pages)
- e3 buggy (24 pages)
- e3 twin buggy (20 pages)
- espresso buggy (4 pages)
- kiwi explorer buggy single & double (6 pages)
- traveller (pre-2013) (43 pages)
- T2 travel cot (12 pages)
- kiwi traveller cot (2 pages)
- highpod (42 pages)
- metoo (22 pages)
- lobster (40 pages)
- airlight (32 pages)
- emotion (32 pages)
- parade (28 pages)
- metro 2014 (32 pages)
- escape 2014 (36 pages)
- metro v2 2009 (42 pages)
- escape v2 2009 (10 pages)
- metro v1 (12 pages)
- escape v1 (12 pages)
- pepe v1 (12 pages)
- bebe hs (4 pages)
- bebe (5 pages)
- quest (20 pages)
- optimum (44 pages)
- evolution (26 pages)
- cocoon genius (26 pages)
- columbus (10 pages)
- tott v1 (8 pages)