phil&teds e3 buggy - Manual (Page 9)

six: insert baby
Apply brakes and insert baby using safety
harness. (Ted stood in for baby!)
1.
Unclip 4 buckles on breastplate
(circled in red) and place baby
in buggy.
2. Adjust upper straps to fit snugly on
baby’s shoulders.
3.
Breastplate should sit snugly on your
baby’s chest. Adjust side straps until
it sits in correct position. (You should
be able to fit 2 average size fingers
between straps and baby.)
4.
Adjust crotch strap length (under or
over webbing loop) for a comfortable fit.
1.
Pull up seat fabric and attach to
lower snaps on handle – both left
and right side.
2.
Attach snaps on back of sunhood to
higher snaps on handle, both left and
right sides.
five: hooding up
3.
Move to front of buggy and secure
snaps on front of sunhood to seat.
WARNING: Ensure harness is used and properly adjusted at
all times.
7 6
Note that the windows in the hood are lined with a sun mesh of
a lower shade factor than buggy fabric. Always use sun cream
and clothing for protection of children in direct sunlight.