phil&teds e3 buggy - Manual (Page 12)

baby ` toddler buggy
(carry a newborn baby & child)
To use baby ` toddler position requires
purchase of double kit accessory.
Double seat height can be adjusted by
undoing snaps on back of double frame,
sliding down fabric and reattaching to lower
set of snaps.
Each plastic hinge is specific to right or left
side of double seat and is marked L or R. (Left
and right are your left and right when standing
behind double seat with it facing forward).
To attach retaining strap:
1.
Remove double seat from buggy or carton.
2.
Remove double frame from fabric sling.
3.
Slide retaining strap loop onto double
frame, and move strap to top of frame.
4.
Slide fabric back onto sling.
ones ` twos
Setting up the baby ` toddler buggy:
1. Ensure that buggy is in newborn
position. Put brakes on.
2.
Remove bumper bar from front of
buggy by pressing silver buttons in on
side tubes.
3.
Insert hinges into double seat - L and
R specific with hinges facing towards
buggy (as shown).
4.
Insert double seat into side tubes using
plastic hinges ensuring silver buttons
engage through buggy frame holes.
11 10