Control pad on the dehumidifier – Perfect Aire PAD70 User Manual
Page 5

Power
Press to turn the dehumidifier on and off.
:
Up/Down Pads
Humidity Set Control Pads
The humidity level can be set within a range of
35%RH (Reliative Humidity) to 85%RH (Relative
Humidity) in 5% increments.
For drier air, press the pad and set to a lower
percent value (%).
For damper air, press the pad and set a higher
percent value (%).
The recommended standard setting is 45-50%.
You must be on Normal Fan mode to set the humidity.
Timer
Press to initiate the Auto start and Auto stop feature,
in conjunction with the and key pads. Timer range
0.0 to 24 hrs.
4
Control Pad On The Dehumidifier
NOTE: The control panel of the unit you purchased may be slightly different according to the models.
When you push the button to change
opertation modes, the unit will make
a beep sound to indicate that it is
changing modes.
Continue
Press to activate the continuous dehumidifying
operation. When operating in this mode the
Up/Down pads will be deactivated and you
will NOT be able to set your desired humidity.
Filter
The check filter feature is a reminder to clean the
Air Filter for more efficient operation. The Filter light
(Clean Filter Light) will illuminate after 250 hours of
operation. To reset after cleaning the filter, press the
Filter pad and the light will go off.
Fan
Control the fan speed. Press to select either High or
Normal fan speed. Set the fan control to High for
maximum moisture removal. When the humidity has
been reduced and quiet operation is preferred, set the
fan control to Normal.
•
Control Pads
1
2
3
4
5 7
6
3
High fan
indicator light
Filter
Full
Cont.
On
Off
Turbo
Normal
Auto defrost
1
2
4
5
6
7
Clean filter
indicator light
Continuous
operation on
indicator light
Timer on/off
indicator light
Bucket full
indicator light
Auto defrost operation on
indicator light
Low fan
indicator light
Cont.