Philips QC5510-65 User Manual
Page 7
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Cleaning the Cutting Element and
Comb After Each Use:
n Make sure the Clipper is switched OFF
and disconnected from the electrical outlet.
B Remove any comb attachment (fig. 10).
B Blow and/or shake out any hair that may
have accumulated in the comb.
Q Rinse the comb under the tap or clean it
with the cleaning brush supplied.
H Put your thumb on the center of the cutting
element and put your index finger on the
teeth of the cutting element. Lift your index
finger (1) so the cutting element releases
from the swivel head (2) (fig. 13).
Be careful that the cutting element does not fall to
the floor
□
Clean the cutting element under the tap
or with the brush supplied (fig. 14).
Make sure the cutting element is thoroughly dry
before reattaching to Clipper
B Clean the inside of the swivel head with the
brush supplied.
B Clean the handle and the adapter with the
cleaning brush supplied or with a dry cloth.
□
Insert the notch of the cutting element into
the slot on the swivel head and push until the
cutting element‘clicks’ into place (fig. 15).
This Clipper has no other user-serviceable parts.
For assistance call I -800-243-3050.
Assistance
For assistance, visit our website:
call toll free: 1-800-243-3050
Information is available 24 hours a day, 7 days a
week.
Storage
►
Be sure Clipper is turned OFF. Remove cord
from outlet and Clipper before storing in a
safe, dry location where it will not be crushed,
banged, or subject to damage.
I Do not wrap cord around Clipper when
storing.
> Store cord in a safe location where it will not
be cut or damaged.
I Do not place or store Clipper where it can fall
or be pulled into a tub or sink, water or other
liquid while plugged in.