Philips QC5510-65 - Manual (Page 6)

Contouring without a comb
attachment
I Use the Clipper without a comb attachment to
clip very close to the skin (3/64 in/imm).
t
Be careful when you are clipping without a
comb as when the Clipper is turned on it will
remove every hair it touches.
n Remove the comb by pulling it off the swivel
head (fig. 10).
Never pull at the flexible top of the comb. Always
pull at the bottom part.
B To contour the hairline around the ears,
comb the hair ends over the ears.
B Push the ON/OFF switch up to turn on the
appliance.
D To contour around the ears, tilt the Clipper
in such a way that only one edge of the
cutting element touches the hair ends. Only
cut the hair ends.The hairline should be close
to the ear (fig. 11).
B To contour the neckline and the sideburns,
turn the Clipper and make downward
strokes (fig. 12).
NOTE: Move the Clipper slowly and smoothly
Simply follow the natural hairline.
Q Adjust the position of the swivel head to
make contouring easier.
Cleaning
> Clean the Clipper after each use.
> Always switch Clipper OFF, unplug and remove
power supply cord from Clipper before
cleaning.
> Do not use compressed air, abrasive cleaning
agents, scourers or aggressive liquids such as
gasoline, acetone or ethereal oils to clean
the Clipper and attachments.
I Never clean, replace or remove Clipper
attachments with motor ON.
> Do not use Clipper if cutter or cutting
element are damaged or broken as injury may
occur.
> Use a soft, dry cloth to clean Clipper handle.
During Use:
> If cut hairs have accumulated in the comb
area, remove hairs by shaking, blowing or using
cleaning brush provided.