Char-Broil 463263111 - Manual (Page 16)

Upper back panel
6
5
1/4-20x1½”
screw
7mm lock
washer
7mm flat
washer
16
On back of grill, place upper back panel between side panels and above lower back panel. Secure upper back panel, in
lower hole, using one 1/4-20x1½” screw, 7mm lock washer, and 7mm flat washer on each side.
Do not fully tighten screws until side shelf installation is complete in later steps.
Pull out the knobs from control panel. Insert temperature gauge stem into the biger hole above knob bezel,shown A.
Make sure the gauge is pushed in as far as it will go, then push the gauge downward until it clips into the panel, as
shown in B/C. Re-install the knobs.
Knob
Knob bezel
Temperature gauge
Temperature gauge stem
Control panel
A
C
B
Back of the panel