Clarion DXZ858RMP - Manual (Page 35)

English
280-8188-00
DXZ858RMP
35
Common Operations
Displaying messages (MSG
INFO)
This function allows you to display a message
on the display when no operation is performed
for more than 30 seconds.
• The factory default setting is “OFF”.
1. Press the [ADJ] button to set to the adjust
mode.
2. Touch [APPEARANCE].
3. Touch on the left of the display to
select "MSG INFO".
ADJ APPEARANCE
RTN
MSG I N F O O F F
4. Touch on the right of the display to
select “ON” or “OFF”.
5. Press the [ADJ] button to return to the
original mode.
Entering messages to display
in message information (MSG
INPUT)
• Up to 30 characters can be entered.
• The factory default setting is “Active MatriX
Control System”.
1. Press the [ADJ] button to set to the adjust
mode.
2. Touch [APPEARANCE].
3. Touch on the left of the display to
select "MSG INPUT".
ADJ-APPEARANCE
RTN
MSG INPUT [ENT]
4. Touch [ENT].
The mode changes to the message entry
mode.
5. Touch [ ]/[ ] to determine the entry
position.
MESSAGE INPUT
MEMO
FONT
A A-Z
RTN
TEXT
A c t i v e M a t
6. Touch on [FONT] to select the type of
text.
Each touch of
switches the type of
text. For details, see page 32.
7. Touch on [TEXT] to determine the
character to enter.
8. Repeat steps 5 to 7 to enter the message.
9. Touch [MEMO].
You will hear a long beep, and the message
is stored in memory.
10. Press the [ADJ] button to return to the
original mode.
Setting the auto-dimmer
(DIMMER IN)
This function allows you to dim the lighting of
the display matched to the illumination or the
brightness inside your car.
Select either “AUTO” (interlocked to the
brightness inside your car) or “ILLUMI”
(interlocked to the illumination inside your car)
as the auto-dimmer setting.
• When the auto-dimmer function is set to
“AUTO”, the brightness of the display is
dimmed according to the brightness detected
by this sensor.
• Set the dimmer setting at DMR LEVEL.
• The factory default setting is “AUTO”.
1. Press the [ADJ] button to set to the adjust
mode.
2. Touch [APPEARANCE].
3. Touch on the left of the display to
select “DIMMER IN”.
ADJ APPEARANCE
RTN
D I MMER I N A U T O
4. Touch on the right of the display to
select “AUTO” or “ILLUMI”.
5. Press the [ADJ] button to return to the
original mode.
+DXZ858RMP_01-29-Eng.p65 1/21/05, 5:48 PM 35