Clarion DXZ858RMP - Manual (Page 17)

English
280-8188-00
DXZ858RMP
17
1. Touch [BAND] to select the desired band
(FM or AM (MW, LW)).
2. Tune into a station.
∗ If "MANU" is displayed, touch and hold
[BAND] for 1 second or longer.
Automatic tuning is possible when "SEEK"
is displayed.
∗ If “TA” is lit in the display, TP stations are
automatically sought.
DX SEEK
When
is touched on the frequency
display, automatic tuning starts.
When is touched, the station is sought in
the direction of higher frequencies; when is
touched, the station is sought in the direction of
lower frequencies.
∗ When seek tuning starts, “DX SEEK” appears
in the display.
LOCAL SEEK
When
is touched on the frequency
display, local seek tuning is carried out.
Broadcast stations with good reception
sensitivity are selected.
∗ When local seek starts, “LO SEEK” appears
in the display.
Manual tuning
There are 2 ways available: quick tuning and
step tuning.
In the step tuning mode, the frequency changes
1 step at a time. In the quick tuning mode, you
can quickly tune the desired frequency.
1. Touch and hold [BAND] for 1 second or
longer if “SEEK” is displayed.
Manual tuning is possible when “MANU” is
displayed.
2. Operate the frequency display to tune to a
frequency on which there is a broadcast.
● Step tuning
Touch
on the frequency display.
● Quick tuning
Touch
on the frequency display. Tuning
stops when you take your finger away from the
panel.
Recalling a preset station
Recalling a preset station is a function for tuning
pre-stored stations.
Radio Operations
1. Touch [PRESET].
The preset memory No. list is displayed.
2. Touch the preset memory No.
∗ In the standard operation display, preset
No. can also be tuned by touching .
■ To cancel tuning
1. Touch [RTN].
Preset memory
A total of 24 preset positions (6-FM1, 6-FM2, 6-
FM3, 6-AM) exists to store individual radio
stations in memory.
1. Touch [BAND] to switch the reception band.
2. Operate the frequency display to tune to a
frequency to store.
3. Touch [PRESET].
The preset memory No. list is displayed.
4. Touch and hold the preset No. to store the
station to for 2 seconds or longer.
You will hear a long beep, and the station is
stored in memory.
Auto store
Auto store is a function for storing up to 6
stations that are automatically tuned in
sequentially.
1. Touch and hold [PS/AS] for 2 seconds or
longer.
“A-STORE” is displayed.
∗ Stations with good reception are
automatically searched, and are stored to
preset memory (No.1 to No.6) in order
from the station having the lowest
frequency.
Notes:
• When auto store is performed, stations stored to
memory so far are cleared.
• When there are fewer than 6 stations with good
reception in LOCAL SEEK, low frequencies are
automatically returned to, and auto store is
performed again by DX SEEK. If there are fewer
than 6 stations even after auto store is performed
twice, stations stored so far remain in memory.
• If auto store is performed in the FM bands, the
stations are stored in FM3 even if FM1 or FM2
was chosen for storing stations.
+DXZ858RMP_01-13-Eng.p65 1/21/05, 2:31 PM 17