Philips QG3260-41 - Manual (Page 8)

Table 2. Beard Trimmer
Remaining hair length
(mm)
Remaining hair length
(in.)
2mm 5/64 in
4mm 5/32 in
6mm 1/4 in
8mm 5/1 6 in
10mm 13/32 in
12mm 15/32 in
14mm 9/1 6 in
16mm 41/64 in
18mm 23/32 in
I REMEMBER:You must reset the hair length
selector back to your desired setting every time
you replace the comb on the appliance
I The remaining hair length corresponds with
the smallest distance between the cutting
blade and the spot where the comb is in contact
with the skin.
Beard Trimming Without
Beard & Moustache Comb
Remove comb if you are:
k Defining hair lines
I Trimming nape of neck
I Removing single, unwanted hairs
D
Be certain the Groomer is in the OFF
position.
B Remove the comb by pressing the Hair
Length Setting Selector (1) and slide the
comb upwards (2). Pull comb off Groomer.
B Switch the Groomer ON.
D
Make well-controlled movements.Touch the
hair/skin lightly with the Groomer.
Styling/Contouring with Precision
Trimmer
I Use the precision trimmer to cut shapes in
beard hair or scalp hair.
> Be careful when using the precision trimmer as
it removes every hair it touches.
D
Put the precision trimmer on the Groomer
handle (fig. 16).
B
Make careful and controlled movements with
the precision trimmer.
B
For best results, move the precision trimmer
against the direction of hair growth making
sure it is in full contact with the skin (fig. 17).
Shaving With Mini Shaver
Use the narrow mini shaver to shave along con­
toured edges to remove any stubble while creating
a smooth, well-defined beard line.
I Before using the mini shaver, always check it
for wear and damage. If the mini shaver shows
signs of wear or damage, do not use it as injury
may occur. Do not use the mini shaver until it
has been replaced.
D Pre-trim the contours desired with the
trimmer or precision trimmer without a
comb attachment.
B
Put the mini shaver on the Groomer handle.
B
Gently press the mini shaver onto the skin
and shave along contoured edges to remove
any stubble. Do not press too hard (fig. 18).