Philips QG3260-41 - Manual (Page 10)

Cleaning
I Clean the attachments after each use.
k Always switch Groomer OFF, unplug
and remove power supply cord from
Groomer before cleaning.
k Do not use compressed air, abrasive cleaning
agents, scourers or liquids such as alcohol,
benzene, bleach or acetone to clean the
Groomer and attachments.
I Never clean, replace or remove Groomer
attachments with motor ON.
k Do not apply pressure to cutters.
I Do not touch cutters with hard objects as this
may damage them.
During Use:
> If cut hairs have accumulated in the comb
area, remove hairs by shaking, blowing or using
cleaning brush provided. Remember to adjust
the trimming length back to your selected set­
ting when you replace the comb on Groomer.
After Each Use:
D
Make sure the Groomer is switched OFF
and disconnected from the electrical outlet.
B Remove any comb or attachment.
Q Blow and/or shake out any hair that may
have accumulated in the comb or attachment.
Q Clean the combs, attachments and appliance
with the supplied cleaning brush or a dry,
soft cloth.
B Place the attachment back on the Groomer
handle.
Cleaning the Mini Shaver
D Separate the top part of the mini shaver
from the bottom part (fig. 23).
B
Blow and/or shake out any hair that may
have accumulated inside the mini shaver
(fig. 24).
B
Clean the top part of the mini shaver under
warm tap water (fig. 25) or with the cleaning
brush.
I The shaving foil is very delicate and should not
be handled.
I If foil becomes damaged, do not continue using
the mini shaver. Do not apply pressure to
shaving foil.
I Do not clean the foil with the supplied brush,
as this may cause damage.
□ Shake excess water from mini shaver and
allow to dry thoroughly.
Do not use a towel to dry the mini shaver as
damage to the shaving foil could occur
This Groomer has no other user-serviceable
parts. For assistance call 1-800-243-B050.