Philips QC5530-15 - Manual (Page 9)

Cleaning
> Clean the Clipper after each use.
> Always switch Clipper OFF, unplug and remove
power supply cord from Clipper before
cleaning.
I Do not use compressed air, abrasive cleaning
agents, scourers or aggressive liquids such as
gasoline, acetone or ethereal oils to clean
the Clipper and attachments.
I Never clean, replace or remove Clipper
attachments with motor ON.
I Do not use Clipper if cutter or cutting
element are damaged or broken as injury may
occur.
> Use a soft, dry cloth to clean Clipper handle.
During Use:
k If cut hairs have accumulated in the comb
area, remove hairs by shaking, blowing or using
cleaning brush provided.
Cleaning the Cutting Element and
Combs After Each Use:
D
Make sure the Clipper is switched OFF
and disconnected from the electrical outlet.
B Remove any comb attachment (fig. 12).
B
Blow and/or shake out any hair that may
have accumulated in the comb.
□ Rinse the comb under the tap or clean it
with the cleaning brush supplied.
H Apply pressure to the center of the cutting
element with your thumb (1) until it releases
from the swivel head (2) (fig. 15).
Be careful that the cutting element does not fall to
the floor
n Clean the cutting element under the tap
or with the brush supplied (fig. 18).
Make sure the cutting element is thoroughly dry
before reattaching to Clipper.
B Clean the inside of the swivel head under the
tap or with the brush supplied (fig. 19).
Q Clean the handle and the adapter with the
cleaning brush supplied or with a dry cloth.
B Insert the notch of the cutting element or
precision trimmer into the slot on the swivel
head and push until the cutting element
‘clicks’ into place (fig. 20).
This Clipper has no other user-serviceable parts.
For assistance call I -800-243-3050.