Philips 32PT663R - Manual (Page 30)

R emote C ontrol U se with A ccessory D evices - S earch M ethod
F our TV remote can be set to work various
external devices such as VCRs, Cable
Boxes, Satellite Receivers, DBS, DVD, etc. by
what is called the search method of remote
control programming.
If the “Remote Code" number method shown
on the previous page did not set your remote
to work your external device, then follow the
easy steps listed below.
Please read steps 1-4 before beginning.
I Press the POWER button on the
device your are attempting to program
to turn it ON.
2 Place the TV/VCR/ACC Mode
Switch in the proper position.
3 Press the VCR • RECORD and the
AUTO SOUND buttons simultane­
ously and hold them down.
4 The device will begin to change chan­
nels after the remote identifies the cor­
rect code. When the channels start to
change release the VCR • RECORD
and AUTO SOUND buttons. The
remote should be ready to operate the
device.
Satellite Receiver
H elpful H int
This method can take up to two minutes to
perform.
Don’t let the device scan up more than five
channels. If you do the remote may pass up
the right code and another two minute search
cycle will have to be repeated.
If no channel change happens within two
minutes, repeat steps 1-4. Should a channel
change still not occur, the remote will not
work the desired device.
NOTE: Setting up the remote is for use with
external accessory devices only and not for use
with other television brands.
Cable Converter
30