Compaq OSI/FTAM D43 - Manual (Page 83)

Compaq FTAM Responder Diagnostic Messages
OSI/FTAM Responder Manual — 425199-001
A -15
Selection-Related Diagnostic Messages
3027
Cause. An invalid value was detected in an attribute on the create or select service.
This message is caused if the filename attribute cannot be decoded or is invalid for the
file system.
Effect. The service fails.
Recovery. The application or FTAM user should correct the value for that attribute and
retry. For possible limitations on attribute values that the Compaq FTAM responder
supports, see Section 4.
3028
Cause. The requested access specified on a select request was inconsistent with the
contents-type attribute specified when the file was created. The responder can return
this error in two cases:
•
nAny file other than an FTAM-2 file was selected for insert access. Insert access is
allowed only on FTAM-2 files.
•
nAn FTAM-2 file was selected for replace or extend access, or both. Replace and
extend access is not allowed on FTAM-2 files.
Effect. The service fails.
Recovery. The application or FTAM user should retry with requested-access values that
are valid for the contents type.
3029
Cause. The negotiated functional units were inconsistent with the requested access type
specified on the select or create service.
Effect. The service fails.
Recovery. The application or FTAM user should establish a new association providing
the required functional units.
3030
Cause. The create request succeeded in creating a Guardian file, but the select regime
has not been established because the requested access was not correct.
Bad attribute value
Requested access violates permitted actions
Functional unit not available for requested access
File created but not selected