Philips 32PT740H37A - Manual (Page 2)

tight.
Cable Box (w/RF In/Outputs):
This connection will NOT supply Stereo sound to the TV. The sound
rom the cable box will be mono.
( Connect the open end of the round Cable Company sup­
plied cable to the cable signal IN(put) plug on the back of
the Cable Box.
Using a separate round coaxial cable, connect one end to the
OUT(put) (TO TV) plug on the back of the Cable Box.
Cormect the other end of the round coaxial cable to the
75Q input on the back of the television. Screw it down finger
tight.
NOTE: Be sure to set the OUTPUT CHANNEL SWITCH on the
back of the cable box to CH 3 or 4, then tune the cable box on the
TV to the corresponding channel. Once tuned, change channels at
he cable box, not the television.
Cable Box with RF Inputs and Outputs Connection:
Output Channel Switch
Cable Signal
IN from the
Cable
Company
Jack Panel Back
of Cable Box
CABLE
IN
Round 75Í1
Coaxial Cable
Jack Panel Back of TV
Cable Box (w/AudioA^ideo Outputs):
This connection will supply Stereo sound to the TV.
I Connect the open end of the round Cable Company sup­
plied cable to the cable signal IN(put) plug on the back of
the Cable Box.
2 Using a RCA type Video Cable, connect one end of the
cable to the Video (or ANT, your cable box may be labeled
differently) Out jack on the cable box and the other end to the
AV1 Video Input on the TV.
3 Using a RCA type Audio Left and Right Cable, connect one
end to the left and right Audio Out L & R Jacks on the
cable box. Connect the other end to the AV 1 Audio L & R
Input jacks on the TV.
NOTE: Use the AV button on the TV remote control to tune to the
AVI channel for the cable box signal. Once tuned, change channels at
he cable box, not the television. Pressing the AV button rep>eatedly
will scroll all the AV Input channels, including the presently timed
channel.
Cable Box with AudioA^ideo Outputs Connection:
Cable Signal IN
from the Cable
Company
Jack Panel Back
of: Cable Box with A/W Outputs
A ntenna TV
A combination antenna receives normal broadcast chan­
nels (VHF 2-13 and UHF 14-69). Your connection is
easy because there is only one
75Q (ohm) antenna plug on
the back of your TV, and that’s where the antenna goes.
I lf your antenna has a round cable (75 ohm) on the end,
then you're ready to connect it to the TV.
If your antenna has flat, twin-lead wire (300 ohm), you
first need to attach the antenna wires to the screws on a
300- to 75-ohm adapter.
2 Push the round end of the adapter (or antenna) onto the
75i2 (ohm) plug on the back of the TV. If the round end of
the antenna wire is threaded, screw it down finger tight.
3 Plug the television in to the wall outlet and turn the TV
on. Refer to the TUNER and AUTOPROGRAM features
within the Directions for Use. TUNER should be set to the
ANTENNA option. AUTOPROGRAM can be set to program
all the available channels on your antenna signal into the tele­
vision’s memory.
Antenna Connection:
Outdoor or Indoor Antenna
(Combination VHF/UHF)
The combination anleima receives normal
broadcast channels 2-13 (VHF) and 14-69 (UHF).
Jack Panel
Back of TV
AC Power
Wall Outlet
I________________ I
Round 75Q
Coaxial Cable
from Antenna
Power Plug
from back of TV