Philips T765-60 - Manual (Page 5)

Cordless Trimming
I Charge according to directions. Unplug
Trimmer from outlet and remove cord.
I Slide ON/OFF switch ON to begin trimming.
I If the battery is empty and you want to trim
your beard, charge the Trimmer for at least
90 minutes and you will have enough power
for one use (10 minutes).
Trimming
I Use this Trimmer for its intended household
use as described in this manual.
I Always comb the beard and/or moustache with
a fine comb before you start trimming.
► If you are trimming for the first time, be careful.
Do not move the Trimmer too fast. Make
smooth and gentle movements.
Trimming with AccuControl
Guide Comb Attachment
I Guide Comb Attachment must be on Trimmer
in order to use the Zoom Lock.
n Turn the Zoom Lock to the desired trimming
length setting (see table).The setting will
appear in the window below the Zoom Lock
(fig- 4).
► If you are trimming for the first time, start by
using the maximum trimming length setting (#9)
to prevent accidentally trimming hairs too
short. As you become familiar with the settings,
adjust Zoom Lock to desired trimming length.
Zoom Lock will “click” into position at each
setting.
D
Switch the Trimmer ON.
Q To trim in the most effective way, move the
Trimmer against the direction of hair growth.
Make sure the surface of the Guide Comb
always stays in contact with the skin (fig. 5).
NOTE: Since all hairs do not grow in the
same direction, you may want to try different
trimming positions (i.e.. upwards,
downwards, or across/. Practice is best for
optimum results.
D If cut hairs have accumulated in the
Guide Comb, turn Trimmer off, remove
the Comb Attachment and blow and/or
shake the hair out of the comb.The
selected trimming length setting will not
change when you do this (fig. 6).