OmniSistem PR Pilot 575 Wash - Manual (Page 12)

PILOT WASH 575 EN.doc 12/16
colour filters or housing of the apparatus
LIGHT OUTPUT
35° DIAMETER (m)
3
5
°
1
5
°
9800
2350
1.3
5
3.15
4m
15° DIAMETER (m)
DISTANCE (m)
0
0
0
5m
15° （ lux）
2m
2m
0m
4m
3m
1m
3m
1m
5m
35° （ lux）
9.45
3.94
15
2.63
6.3
10
5.26
12.6
20
610 2400 1090
140 588 90
25
15.7
6.58
65
390
PROBLEM POSSIBLE CAUSE ACTION
The projector doesn’t
switch on
­The power supply is not
present
­The lamp doesn’t work Check the fuse on the power
socket.
Replace the lamp.
The lamp comes on but
the projector doesn’t
respond to the controller ­Wrong DMX configuration
and/or start address
­ Defective DMX cable Make sure that the projector is
correctly configurated.
Replace or repair the DMX
cable.
The projector only
functions intermittently
­The fan has failed Make sure the fan is working
and not dirty.
Defective projection ­The lens is broken
­Dust or grease on lenses Check the lenses are not
broken.
Remove dust or grease from
the lenses.
The projected image
appears to have a halo ­Installation of the lamp is
not correct
­Dust or grease
contamination on the
optics. Make sure the lamp is installed
correctly.
Carefully clean the optical
group lenses and the projector
components.
The beam appears dim ­Dust or grease
contamination on the
optics.
­The lamp is at the end of
its life Check the optics is clean.
Replace with a new lamp of the
specified type and rating.
TROUBLESHOOTING